With these commands you can edit the corner points and edges of the displayed (i.e. active) layers of slabs.
Select the displayed layer in the Slab properties - Layers dialog box. An arrow marks the displayed layer.
|
You can access editing commands from the Shortcut menu:
|
|
&The operation of this command corresponds to those described in chapter 9.4.3. Editing commands for whole slabs.
Moving nodes
Click on any corner point of the active slab layer to modify its position
Parallel shifting (Offset)
With this command you can offset one side of the active slab layer or enlarge or reduce the entire contour of the slab.
Inserting nodes
Click on any side of the active slab layer to insert a new node to that layer.
Adding polylines
Click on any side of the active slab layer to add multiple nodes by a polyline to the slab.
Deleting nodes
This command deletes any selected corner point of the active slab layer.
Converting lines to arcs
This command performs the following conversions:
The command converts linear slab sides to arced ones; if the selected side of the slab is arced, you can also modify the radius of the arch.
Converting arcs to lines
Use this command to convert arced slab sides to linear ones.
